Electronics Forum | Mon Sep 19 09:16:24 EDT 2016 | markhoch
Hi Shriram, Are you saying that there is a trace running between the pads for this 0603 capacitor? If so, this design may be causing a gasketing issue between the stencil and the PCB. The uneven height prevents the stencil from sitting flat on the PC
Electronics Forum | Mon Sep 19 01:57:28 EDT 2016 | shriram
Hi guys, Problem: Mid chip solder balling. Component affected: 0603 caps only Defect is PCB specific (Meaning only one PCB is affected as the aperture is standard for that component). As a containment I'll give a home plate design for the compo
Electronics Forum | Wed Oct 11 15:40:34 EDT 2006 | Steve Gregory
Don't think there's any easy way to clean under a LCC, but you might want to consider this: http://www.winslowautomation.com/ccmd.asp A dead simple way to mount solder columns onto LCC's and then solder the part to the PCB with a stand-off of abou
Electronics Forum | Mon Aug 09 17:02:32 EDT 2004 | arminski
Hi Shean, Thanks for the analysis. "Your product looks like it may have non-solder-mask-defined pads." Yes. It is a NSMD PCB. "Does there appear to be any residues on the bare boards, and/or, BGA components prior to applying the solder paste?"
Electronics Forum | Wed Aug 04 16:09:48 EDT 2004 | Dreamsniper
Hi, Thanks for your reply. I run 2 boards, using the same paste, thermal profile and the same method of aqueous cleaning, 1st is a Topline test board with topline BGA (BGA 272 with 1.27 Pitch) and the 2nd is our product PCB with our BGA from Motoro
Electronics Forum | Sun Jul 25 08:54:37 EDT 1999 | Tom Gervascio
| We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after
Electronics Forum | Fri Jul 30 09:43:44 EDT 1999 | C.K.
| We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after
Electronics Forum | Fri Jul 23 14:07:52 EDT 1999 | Carl J. Odle
We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after a p
Electronics Forum | Mon Jul 26 10:25:12 EDT 1999 | Boca
| | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that a
Electronics Forum | Mon Jul 26 14:14:51 EDT 1999 | Steve Gregory
| | | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is th
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
